Page 4
SKU 90099
Assembly
Follow the Assembly Drawing on page 6.
Note:
Assemble and use the Canopy on a flat, level surface. Do not situate the Canopy near
any type of heat source. Do not set up the Canopy in windy or snowy conditions. It is
suggested that two people assemble the Canopy.
1. Attach each
Top Tube (#1)
to the
Top Joint (#8)
.
2. Attach an
Upper Tube (#2)
to each
Top Tube (#1)
.
3. Attach a
Corner Joint (#7)
to the end of each
Upper Tube (#2)
.
4. Insert a
Cross Tube (#3)
on each side of the
Corner Joint (#7)
.
5. Insert and attach a
Mid Cross Tube (#4)
between each of the
Cross Tubes (#3)
on each
side, as shown on the Assembly Drawing on page 6.
6. Now that the roof structure is assembled, drape the Canopy over it making sure the leg
sections of the Canopy correspond with each corner. Connect each of the velcro ties on the
Canopy to the
Mid Cross Tube (#4)
on each side.
7. Put a
Base Plate (#11)
on the bottom of each
Lower Leg (#6)
.
8. Attach an
Upper Leg (#5)
to the other side of each
Lower Leg (#6)
.
9. Attach the
Upper Leg (#5)
to the
Corner Joint (#7)
.
10. Repeat with three other corners. Over each leg, fold down the Canopy leg cover
sections on each corner.
11. In each corner, insert a
Ground Peg (#10)
through the triangular brace inside the corner
tube of the Canopy, through the “D” ring and then firmly into the ground.
12. Repeat on the other three corners.
Maintenance
1. Check the frame structure for bend, cracks, or breaks. If any are discovered, disassemble
the Canopy and have the affected tubes replaced.
2. Check the Canopy for fraying or tears. If any are discovered, disassemble the Canopy
and have the Canopy repaired.
3. Do not let dirt, leaves, or any debris build up on the Canopy.
