7
One Identity Safeguard for
Privileged Sessions VMware
Installation Guide
This tutorial describes the possibilities and limitations of installing One Identity Safeguard
for Privileged Sessions (SPS) 6.0 as a virtual appliance under a VMware ESXi server.
Installing SPS under VMware ESXi/ESX
The following describes how to install a new SPS under
VMware ESXi or ESX
.
To install a new SPS under VMware ESXi or ESX
1. Create the virtual machine for SPS using the following settings. Note that these
settings are suitable for evaluation purposes. To test SPS under significant load,
contact One Identity for recommendations.
l
Guest operating system:
Linux/Ubuntu 64-bit
l
Allocate memory for the virtual machine. SPS requires a minimum of 4 GiB (8
GiB is recommended) of memory. The recommended size for the memory
depends on the exact environment, but consider the following:
l
The base system requires 4 GiB of memory.
l
SPS requires about 1-5 MiB of memory for every active connection,
depending on the type of the connection — graphical protocols require
more memory.
l
The hard disk controller must be
LSI Logic Parallel
.
l
Do not use RAID for the hard disk, use the data duplication features of your
virtual environment instead. That way, a single hard disk is sufficient for the
system. If you need to use the built-in RAID support of SPS for some reason,
use two hard disks, and SPS will automatically use them in software RAID.
SPS 6.0 Installation Guide
One Identity Safeguard for Privileged Sessions VMware Installation Guide
21
