■ ■ ■ ■
■ ■ ■ ■
26
Helpful Hints
Problem:
Solution:
Red light does not
Replace batteries with 4 fresh,
blink when you press
new AAA alkaline batteries.
a key?
The ONE FOR ALL
Make sure you are using new
does not respond after
batteries and are aiming the
pressing a key?
ONE FOR ALL at your device.
The ONE FOR ALL
A) Try all the codes listed for
does not operate your
your brand. B) Try the search
device(s)
method on page 13.
Your brand is not
Try the search method on page 13.
listed in the ONE FOR
ALL code section?
When following the
Did you use the Code Lock
set-up instructions, the feature? You must first unlock
red light on the ONE
the code before entering a new
FOR ALL only blinks
code. Follow the instructions
once instead of twice
on page 22 to do this.
after you enter a
three-digit code?
The ONE FOR ALL
You may be using the wrong code.
is not preforming
Start the search method over
commands properly?
again to locate the proper code.
Press a key but get
Hold MAGIC until the red light
the wrong result?
blinks twice, then press 992 and
the device key twice. You will
need to set-up your device again.
Try the codes for brand or the
search method on page 13.
You cannot control the
Hold MAGIC until the red light
volume feature of your
blinks twice. Then press 993 and
Satellite, Cable
VOL+. To set the volume control
Converter or TV/Video back to TV (Punch Through),
Combination?
hold MAGIC until the red light
blinks twice, then press 993 TV.
Problems changing
Enter the programme number
channels?
exactly as you would on your
original remote.
Video not recording?
As a safety feature on your ONE
FOR ALL, you must press the
Record key twice .
Scan does not work
Make sure your original remote
on your device?
had a pro/- key.
