9.
Place to foam rest pads on the upper support arms
So your equipment will not rest on the metal of the support
arms
10. Carefully place your equipment on the stand and
make sure you do not have less then 3” of over
hang on either side. If you have less then 3”
remove your equipment from the stand and see
step 5.
NEVER move or adjust your stand
with equipment on it to prevent damage
to the stand, your equipment, or personal injury
Folding up for Carrying or Storage
1.
Remove your equipment from the stand.
2.
Loosen height adjusting knobs on both upper supports
and position them all the way down. Tighten the knobs
3.
(This might take two people) Remove the female knobs
with washers holding the box beam assembly to the Z
sections. Remove the box beam.
4.
Take each of the Z sections and unlock the upper and lower
support arms and swing them all the way around until they
are positioned against the center vertical rectangular tube.
5.
Place the two folded Z sections against each other with the
the threaded studs facing up and the height adjusting
knobs facing each other.
6.
Loosen knobs on box beam.
7.
Place box beam on the threaded studs making sure the box
beam is sitting flush and the box beam is not longer then
the folded Z sections. Place washers and thread female
knob on each threaded stud and tighten knobs.
8.
Make sure all knobs are tightened before carrying.
Optional Accessories
KSB-6500 Keyboard Stand Bag
KSA7550 Second Tier
KT7800 3-Position X-Style Bench
4-Position X-Style Bench
