Assembling Instructions for the
KS7350 FOLDING Z KEYBOARD STAND
SETUP
1.
Remove unit from box and inner bag.
2.
Unthread both female knobs with washers from the
treaded stud located where the horizontal and vertical
square tubing of the box beam are connected.
3.
Take the two folded rectangular sections and swing the
upper and lower support arms all the way until they lock
into their position to make two Z sections.
4.
(This might require two people)With the threaded studs
facing each other place the box beam onto the threaded
studs making sure the box beam sits flush with the side
arms of the box beam go around the front and back of the
vertical rectangular tubing. Note the width adjusting knobs
on the box beam and the height adjusting knobs should be
facing the same direction. Secure box beam in place with
the female knobs with washers.
5.
Adjust the width of the stand by loosening the two male
knobs on the box beam and adjust to your desired position
making sure not to have less then 3” over hang for your
equipment on either side. Tighten width adjusting knobs.
6.
Adjust height of the stand by loosening the large knobs on
the vertical rectangular tubing. The first height position is
with the inner rectangular tube all the down inside outer
rectangular tube.
7.
The second height position is when you raise the inner
rectangular tubes to the first hole with a horizontal notch.
Position the horizontal notch on both sides so it positioned
right at the top of the outer tube. Secure the height
adjustment knobs.
8.
Follow step 7 for third to and including the sixth height
positions.
Before you proceed or put any equipment on
your stand is to make sure that all knobs are
tightened to prevent any damage to your
equipment or personal injury.
