NB3x6x1xxG8DFNEVK
www.onsemi.com
3
Step 1: Hardware Setup
Note: Skip this section if device has already been programmed.
Main Board
1. Securely connect the daughter board to the main board by lining up all four 4−pin connectors (J8, J12, J13, J21). The
daughter board can only be plugged in to the main board correctly in one orientation.
2. Make sure all SMA cables are unplugged from main board and daughter board.
3. Jumpers:
a. Use jumpers to provide connection as referenced in table below: (Pin 1 is indicated by a circle)
Jumper No
J26 (SEL1)
J27 (SEL0)
J24 (OE2)
J25 (OE1)
J28 (OE0)
J29 (PD#)
J19
Pin connection
2 and 3
2 and 3
2 and 3
2 and 3
2 and 3
OPEN
2 and 3
4. Switches:
b. Slide switches to the position referenced in table below: (ON position is indicated via lettering on switch)
Switch No
SW1
SW2
Position
ON
ON
5. Rotary Switches:
c. Turn knob on rotary switches as shown in table below: (The position number will be displayed in a slit on the knob)
Jumper No
U11
U12
U13
U14
U15
U16
Dial Display
1
1
1
1
1
1
Daughter Board
1. Jumpers:
a. Use Jumpers to provide connection as referenced in table below: (Pin 1 is indicated by a circle)
Jumper No
J31 (SEL1)
J30 (SEL0)
J29 (OE2)
J28 (OE1)
J27 (OE0)
J26 (PD#)
Shorting Link Position
OPEN
OPEN
OPEN
OPEN
OPEN
OPEN
2. Switches:
b. Slide switches to the position referenced in table below: (ON position is indicated via lettering on switch)
Switch No
SW1
SW2
SW3
Position
ON
ON
ON
3. Ensure that Crystal (XTAL) is in holder.
4. Place NB3H60113G or NB3V60113G in DUT socket U2. For device pin 1 alignment refer to Figure 4.
Содержание NB3x6x1xxG8DFN
Страница 2: ...NB3x6x1xxG8DFNEVK www onsemi com 2 Figure 3 Main Board Figure 4 DFN8 Daughter Board ...
Страница 8: ...NB3x6x1xxG8DFNEVK www onsemi com 8 OUTPUT TERMINATION HCSL CML LVPECL LVDS ...
Страница 12: ...NB3x6x1xxG8DFNEVK www onsemi com 12 DFN8 Daughter Board Schematic Figure 12 DFN8 Daughter Board Schematic ...
