ON Semiconductor ARX3A0-CSP35, Руководство пользователя

Страница: 4 / 6

ARX3A0 − CSP35
www.onsemi.com
4
Jumper/Header Functions & Default Positions
Table 1. JUMPERS AND HEADERS
Jumper/Header No. Jumper/Header Name Pins Description
P7 GPIO0/FLASH Open (Default)
1 +5V0
2 GND
3 GPIO0/FLASH
4 +3V3
P8 SHUTTER / GPIO1 Open (Default) Normal Operation
1−2 Pulled Up
2−3 Pulled low
P10 GPIO2/TRIGGER 3−5 (Default) GPIO2 Pull Down
1−3 GPIO2 Pull Up
2−4 Trigger from Demo3
Pin 4 Function Generator Input
P13 GPIO3 Open (default) Normal Operation / Multi−Camera Slave Mode
1−2 GPIO3 Pulled up
2−3 GPIO3 Pulled down / Master Mode
P15 LED 1−2 (Default) Power LED ON
Open Power LED OFF
P20 CLK Selection 1−3 (Default) Select on−board oscillator clock & enable master clock
output
2−4 Select Slave clock (for slave sensor in multi−camera mode)
3−5 Select Demo3 clock
6−8 Enable Master clock (to support slave sensor in
multi−camera mode)
P24 I
2
C 1−2 & 3−4 (Default) Demo3 SCL & SDA connected to sensor SCL & SDA
respectively
P25, P26 Multi Camera (Slave/
Master)
Refer schematics for the connection
P27 EEPROM Addr. Sel 1−2 Closed &
3−4 Open (Default)
EEPROM Address set to 0xA8
1−2 open &
3−4 Open
EEPROM Address set to 0xAC
1−2 open &
3−4 closed
EEPROM Address set to 0xA4
1−2 Closed &
3−4 closed
EEPROM Address set to 0xA0
P40 TEST 1−2 (Default) Normal Mode Operation
Open Test Mode
P41 ATEST1 Open (Default) Normal operation
Pin 1 & 2 Analog manufacturing test access
P42 VAA Sel 2−3 (Default) VAA is at 2.7 V from the on board LDO
1−2 VAA is at 2.8 V from Demo3 Baseboard
P43 VAA−PIX Sel 2−3 (Default) VAA−PIX is at 2.7 V from the on board LDO
1−2 VAA−PIX is at 2.8 V from Demo3 Baseboard
SW1 RESET N/A When pushed, 240 ms reset signal will be sent to ARX3A0