301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 3 of 3
INSTRUCTION/INSTALLATION SHEET
Selective Call Intercom Room Unit
IS-0386 REV. O
©Copyright 2007 by On-Q/Legrand All Rights
Reserved
.
4. Operation
Please refer to the Selective Call System Installation Manual (P/N 1308003) shipped with the Room Unit for
more detailed instructions on how to use any Selective Call Room Unit to configure and personalize the
Selective Call System. Refer to the Selective Call System User Manual (P/N 1308001) shipped with the
Selective Call Module to familiarize yourself with the operation of the Selective Call Intercom System.
Figure 5
talk/select:
Depressing this button will allow you to
communicate with any active units selected on the LCD
Display. Hold in the talk/select button while speaking, and
let it go when you are done. Your voice will be heard on
the selected Unit, or any active Room or Patio Unit if All is
selected.
monitor:
Press this button once to put the Unit in
MONITOR mode. The LCD will display a message stating
that “MONITOR is On” and the monitor button will change
its normal white backlit color to red. This means that all
other non-Monitored units will be able to listen to this unit.
While in MONITOR mode, the microphone is constantly
active, and any voice or noise within the room will be heard
by any monitoring station. Multiple Units can be in
MONITOR mode at the same time. If someone wants to
contact the monitored unit they must place a selective call
to that unit. Press the monitor button again to return the
Unit back to normal mode. The LCD will tell you “MONITOR
is Off”. If the mute button is also pressed, the LCD will
indicate that you are in MONITOR and MUTE mode and the
unit cannot be contacted.
NOTE: When in MONITOR mode, a door bell button
push at a Door Unit will not result in a door chime ring
at the Room Unit.
volume:
There are two volume control buttons, l
and -. When either button is pressed, the LCD display turns
into a horizontal volume bar graph. Pressing the volume up
button increases the volume (the bar graph moves to the
right). You can also hold in the volume up or down button
until you have reached the desired volume level. The LCD
changes back to its normal display after 2 seconds of
inactivity
mute:
Press this button once to put the Unit in MUTE
mode. The LCD will display a message that you are in
MUTE mode and the button will change its normal white
backlit color to red. Press the button again to return the Unit
back to normal mode. The LCD will display a message that
MUTE is Off. While in MUTE mode, both the speaker and
microphone of the unit will be inactive. MUTE mode is useful
for maintaining privacy in a particular room.
LCD:
This is the Liquid Crystal Display that is used to
customize, personalize and operate the Selective Call
Intercom System. It identifies which unit is calling you, and
gives you status of all the individual units. It also provides
pop-up messages to inform you of specific operational
parameters.
SPEAKER
MICROPHONE
