INSTRUCTION / INSTALLATION SHEET
ev
ō
Q™ 5000 Home Theater 10” 150W
Sub-Woofer
IS-0260 Rev. D
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
©Copyright 2007 by On-Q/Legrand All Rights Reserved.
Page 3 of 3
NOTE: The crossover adjustment on the ev
ō
Q™ 5000
10” 150W Sub-Woofer is used to determine
the frequency point (cutoff point of the low pass filter) at which source input goes to the sub-
woofer (adjustable from 50-200HZ). This adjustment is dependent on the quality of the source
equipment and quality of the rest of the speaker system. Try a variety of source material to insure
the adjustment is appropriate.
NOTE: Some amplifiers reverse the phase of sub-woofer outputs in respect to the phase of the
rest of the speaker outputs. The ev
ō
Q™ 5000
10” 150W Sub-Woofer has a phase reversal switch
on the back that allows for proper phasing regardless of amplifier output. Try both positions of
the switch with bass rich content to determine which position sounds best for a particular
installation.
TIP: To determine the best location for a sub-woofer, place the sub-woofer in the location that
you normally listen to music and walk around the outside of the room until you find a spot that
seems to have the most pronounced bass output. That is the location where the sub-woofer
should be placed. (see
Figure 6
)
ev
ō
Q™ 5000 10” 150W SUB-WOOFER
Size/Type 10"
Floor
Mount
Efficiency Powered
Power (RMS/Peak)
150W RMS
Frequency
Response
35-200K
Woofer Type
Poly
Tweeter Type
N/A
Drywall Hole Size
N/A
Speaker
Specifications
Figure 6