2
F
A
B
C
D
E
LIBRETTO ISTRUZIONI - INSTRUCTION MANUAL
1
2
3
TX
X 10 SEC.
TECHNICAL CHARACTERISTICS:
DESCRIPTION
VALUE
Power supply
3V CR2032 lithium battery
Frequency
433.92 MHz
Degree of protection
IP 56
Consumption during
transmission
27 mA
Number of channels
3 or 5
Antenna
Integrated
Range
100 metres outdoors
Operating temp.
-20/+70 °C
Weight
27 g
The RAD3 transmitter is innovative in design and made with
reinforced plastic, and controls the automation devices of
gates, doors, garage doors (swinging or sectional), shutters
and similar. Any other use of the transmitter is prohibited!
Before programming the RAD3 in the receiver, make sure that it works correctly by
pressing each button in turn to simulate a transmission and checking that the LEDs
light up. The LED turns orange and remains steady during transmission of the code.
If the battery is low, the power of the transmitter will decrease and the LED will flash
during transmission: in which case, replace the low battery with one of the same
type, making sure to put it in the correct way round as shown in the picture.
PROGRAMMING AND CANCELLING THE TRANSMITTER
Program or cancel the transmitter referring to the instructions provided with the control unit or
receiver. The remote control has rolling-code.
5 CHANNEL MODE
There is a default 3 channel mode but also a 5 channel mode:
- channel 1: button 1
- channel 2: button 2
- channel 3: press button 3 and then press button 1 within 5 seconds
- channel 4: press button 3 and then press button 2 within 5 seconds
- channel 5: press button 3 and then press button 3 again within 5 seconds
To enable this mode:
•Open the transmitter and remove the battery; reinsert the battery while pressing and holding buttons
1 and 3 for over 10 seconds (the LED flashes green and red in alternation). Afterwards, the LED flashes
orange 5 times.
•Release buttons 1 and 3 and press button 2 during the fifth flash of the LED.
To revert to 3 channel mode, repeat the procedure but press button 2 during the third flash of the LED.
COPYING A FIXED CODE TRANSMITTER
It can be useful to copy the code of a fixed code transmitter for controlling an existing automation. Proceed as follows:
• Place the 2 transmitters next to each other.
• Press the RAD3 button to be associated with the new code and hold it for about 10 seconds: the LED starts flashing
green.
• While still holding the button, press also the button of the transmitter to which the code is to be copied.
• After programming, the RAD3 LED remains steady for about 1 sec and then stops flashing: at this point, release the
button.
