STAND: 17.06.2019
9910_Operation-Manual_STANDMOVE_M1-0_Rev1v0_EN
Seite 16 von 23
Note:
With the additional stops, the safety of the table system can be increased,
in that the possible movement path is restricted.
Container- and shelf stops are safety positions that cannot be run over during normal operation, so that
collisions with known, permanently present hindrances can be prevented. The container stop
limits the movement height downwards (minimum height) and can be used if there are limiting factors
below the table, for example, a Rollcontainer. The shelf stop limits the movement height of the table
upward. The shelf stop can be used if there are limiting factors above the table, such as a shelf or the
incline of a roof.
Setting the container stop is only possible in the lower half of the movement path of the table and only
below the shelf stop.
Setting the shelf stop is only possible in the upper half of the movement path of the table and only above
the container stop.
The procedure for setting the respective stop is identical. Proceed as follows:
1. Move the table, using the arrow keys ( and ), to the desired position.
2. Press both the arrow keys ( and ) at the same time.
3. The controller confirms with one “click-clack” sound. (The absence of this signal means that
setting is possibly not permitted.)
To delete the container stop, proceed as follows:
1. Keep the arrow key down pressed.
2. The table stops automatically upon reaching the container stop.
3. Press both the arrow keys ( and ) at the same time.
4. The controller confirms with a single “click-clack” sound.
Follow a similar procedure for deleting the shelf-stop.
1. Keep the arrow key up pressed.
2. Steps 2 to 4 are identical to those for deleting the container stop.
If an attempt is made to set the container stop or shelf stop too close to the middle, the controller
signals this with 6 “click-clack” sounds.
