OV1015 | 17
User Guide: OV1015
OPERATION INFORMATION
TROUBLESHOOTING
UNIT
ERROR
SOURCE
SOLUTION
Workstation
does not move
No power supply
Plug in the power cord or check the connection
on the control box
No connection or a loose
connection to the drives
Verify the plug connection of the motor cable
to the control box
No connection or a loose
connection to the handswitch
Verify the plug connection of the motor cable
to the control box
Max lifting capacity
is exceeded
Reduce the weight or load on the tray
Replace the handset
Max time limit is exceeded
Control is activated automatically after approx. 9 minutes
Defective drive
Contact customer service
Defective control box
Contact customer service
Handset is defective
Workstation
moves down at
a slow rate
Control box expects
new reset
Reset control box. (See page 16)
If it is not possible to resolve an error as described, disconnect the power cord, wait a few minutes and reset
the table again. If the error still occurs, remove the table from the power source and contact customer service.
(Error Code list is valid from firmware 1.7.5 and higher)
