OMS KEA 300 TGI, Руководство по эксплуатации и обслуживанию

Страница: 31 / 36

31
CHAPTER 9 TROUBLESHOOTING
9.1 TROUBLESHOOTING
The most common problems that could occur while using the slicing machine are
listed below, along with the most probable causes and solutions for dealing with
them. If the problem continues, contact the authorised service provider.
Control panel - display
3 (Fig. 8) - the following message appears:
Emergency microswitch contact open.
Error reading the carriage forward magnetic
microswitch.
Error reading the carriage back magnetic
microswitch.
For the errors described above, contact your authorised service provider.
PROBLEM PROBABLE CAUSE SOLUTION
The motor does not
start when the start
blade button is pressed.
No power to the
machine.
Check that the machine plug
is inserted correctly.
No power to the
mains.
Check that power reaches
the electrical system outlet.
Faulty electrical circuit. Contact the authorised
service provider.
Under stress, the blade
slows down or stops.
Cutting of products
which are not allowed
(frozen products or
products with bones).
Thaw the product or take
the bone out of the product
to be cut.
Machine set for 400 V.
three phase voltage
but connected to 230
V three phase power.
Unplug the machine from the
mains and contact the
authorised service provider.
The motor starts up
but the machine is very
noisy or the motor
overheats or there is a
bad smell.
Transmission or motor
problems.
Unplug the machine from the
mains and contact the
authorised service provider