5
4c
4
4a
4b
CONNECTION OF AUTONOMOUS FITTING
CONNECTION AND SETUP OF FITTING TO CENTRAL BATTERY
CONNECTION OF FITTING TO FZLV CENTRAL BATTERY
CONNECTION OF FITTING TO RUBIC SYSTEM
SURFACE ASSEMBLY
PRODUCER’S GUIDLINES RELATED TO INSTALLATION PROCEDURE:
- in a fitting the cable L and L1 is required to the maintained mode (SA)
,the non maintained mode (SE) does not require L1 cable
- It is possible to use the included jumper to short circuit L and L1
- during the battery connection, pay attantion to proper polarisation
„+” and „-”
- The first if all you have to connect battery to inverter and then
connect the mains supply
- during the communication cables connection, pay attantion to isolation of
the cable’s shield which can lead to a short circut of the others
communication lines
- CBS fiting address cannot be doubled in a single circut
- during connection to the FZLV system, keep the proper polari” , „-”
- the drawing enclosed in this instruction may be vary than in the finished
products, to a proper connection follow the instruction enclosed in the label
attached on a fitting
- Select the wiring diagram according to the luminaire version
- n the case of mounting flush fitting in suspended ceilings refer to the
instructions of installation, included the manufacturer's instructions ceiling
- in Rubic System It is needed to place on a building plan, an fitting's address
in a place of itnstallation. The address is placed on a fitting's housing
POWER SUPPLY
220÷240VAC/50÷60Hz
CONNECTION BATTERY
!
SURFACE ASSEMBLY
4x
POWER SUPPLY
220÷240VAC/50÷60Hz
CONNECTION COMMUNICATIONS
CONNECTION BATTERY
!
ADDRESS
CONFIGURATION
!
POWER SUPPLY
220÷240VAC/50÷60Hz
175÷275VDC
POWER SUPPLY
24VDC
Risk of electric shock
Risk of electric shock
Risk of electric shock
