Setting the Output Conditions
310
ZW User's Manual
9-8 Setting the Output Conditions
Setting the Filter
Setting the Median Filter
Setting the Median Filter p.94
As an example, here is an explanation of the procedure for selecting the "MID" median filter setting.
Operating procedure
Steps
Key operation
Display
Description
1
Press and hold the
key for two seconds to enter the FUN
mode.
2
Press the
/
key to select MEAS, then press the
key.
3
Press the
/
keys to select "TASK1" and press the
key.
4
Press the
/
keys to select "FILTER" and press the
key.
5
Select "MEDIAN" as the filter type.
Press the
/
keys to select "MEDIAN" and press the
key.
6
Select the filter mode from the following:
OFF / LOW / MID / HIGH
The current setting value is displayed on the sub-display.
Press
/
key to enter editing mode and the sub-display blinks.
In this example, select "MID" and press the
key.
7
Press the
key for two seconds to enter the RUN mode.
Содержание ZW-C1*AT
