Omron V700 series, Руководство по эксплуатации

Страница: 102 / 168

5-12 Section Response Codes
93
5-12 Response Codes
The response codes are described in the following table.
Type Response
code
Name Meaning
Normal end 00 Normal end No error occurred and the command ended normally.
72 Multi-trigger end Communications were completed with multi-trigger mode
specified.
Selective Tag
detection end Communications were completed with selective access “Tag
detect” communications specified. (Tag detection completed.)
74 Polling command
received A polling command has been received normally.
75
Polling process
canceled The polling process was canceled before the completion of
communications with the ID Tag.
Data normal MEMORY CHECK command (MC):
The calculated check code matched the value in the check code
area.
ADD (AD) command:
Command ended normally without an overflow in the result
SUBTRACT (SB) command:
Command ended normally with a result that was not less than 0.
76
Polling process
canceled The polling process was canceled after the start of
communications with the ID Tag.
Data error MEMORY CHECK command (MC):
The calculated check code did not match the value in the check
code area.
ADD (AD) command:
Command ended normally with an overflow in the result.
SUBTRACT (SB) command:
Command ended normally with a result that was less than 0.
Host 10 Parity error A parity error occurred for one of the characters in the command.
communications
error
11 Framing error A framing error occurred for one of the characters in the
command.
12 Overrun error An overrun error occurred for one of the characters in the
command.
13 BCC error A received command had an incorrect BCC.
14 Command error The command frame structure normally received is incorrect.
18 Frame length error ETX was not received in 288 characters or less after STX was
received.
Communications
error
70 Communications
error An error occurred during communications with a Tag and
communications were not completed normally.
71 Verification error A write process error occurred during a write.
72 No Tag error There was no Tag in front of the Antenna when the command was
executed.
7A Address error The address specification is not correct.
7B Not write area error The Tag is in a read-only area.
7C No Antenna
connected error No Antenna is connected.
7D Protection error An attempt was made to write to a write-protected area.
7E ID system error 1 The Tag could not process the command in its current status.
7F ID system error 2 The Tag does not support the command.
System error 9A Sync error The multiple Controllers used were not synchronized for mutual
interference prevention at the time of acceptance of the
command.
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr