52
SE
CTION 3
Set
ting
t
he Communica
tions
Co
ndi
tions
f
or t
he CIDRW Cont
roller
CIDRW System
User’s Manual
SECTION 3
Preparing for Communications
Setting the Communications Conditions for the
CIDRW Controller
Set the communications conditions of the CIDRW Controller only when SECS is used.
Switch to Setting Mode
The CIDRW Controller has two operating modes, the Normal Operation mode and the Setting mode.
Switch to the Setting mode to set the communications conditions.
There are two methods for switching the mode. Use the one that is appropriate for the circumstances.
Changing the Position of the Mode Switch on the Bottom of the Unit
This is the convenient method for setting before mounting the Unit.
1.
Turn OFF the power to the CIDRW Controller.
2.
Set the mode switch on the bottom of the Unit
to 3.
1
2
3
Set Parameters
for
Communications
Conditions.
4
5
6
7
8
Содержание V640-HS61
