Omron SX-F, Инструкция по эксплуатации

Страница: 131 / 316

123
Process and Application Parameters [300]
Section 11-3
Communication information
FB Status [269]
Sub menus showing status of fieldbus parameters. Please see the Fieldbus
manual for detailed information.
11-3 Process and Application Parameters [300]
These parameters are mainly adjusted to obtain optimum process or machine
performance.
The read-out, references and actual values depends on selected process
source, [321}:
11-3-1 Set/View Reference Value [310]
View reference value
As default the menu [310] is in view operation. The value of the active refer-
ence signal is displayed. The value is displayed according to selected process
source, [321] or the process unit selected in menu [322].
Set reference value
If the function Reference Control [214] is set to: Ref Control = Keyboard, the
reference value can be set in menu Set/View Reference [310] as a normal
parameter or as a motor potentiometer with the + and - keys on the control
panel depending on the selection of Keyboard Reference Mode in menu
[369]. The ramp times used for setting the reference value with the Normal
function selected in menu [369] are according to the set Acc Time [331] and
Dec Time [332]. The ramp times used for setting the reference value with the
MotPot function selected in [369] are according to the set Acc MotPot [333]
and Dec MotPot [334]. Menu [310] displays on-line the actual reference value
according to the Mode Settings in Table 24.
Modbus Instance no/
DeviceNet no:
42801-42816
Profibus slot/index 167/215-167/230
EtherCAT index (hex) 4af1-4b00
Fieldbus format UInt
Modbus format UInt
269 FB Status
Stp
Table 24
Selected process
source
Unit for reference and actual
value
Resolution
Speed rpm 4 digits
Torque % 3 digits
PT100

C 3 digits
Frequency Hz 3 digits
Default: 0 rpm
Dependent on: Process Source [321] and Process Unit [322]
Speed mode 0 - max speed [343]
310 Set/View ref
Stp
0rpm