Omron R88D-KN01H-ECT-L, Руководство пользователя

Страница: 130 / 626

3 Specifications
3 - 54
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
The Unit is used with a Connector Terminal Block Cable (Model: XW2Z- J-B34).
They convert the control input signal (CN1) of the G5-series Servo Drive into a terminal block.
z
Terminal Block Models
z
XW2B-20G4
Precautions for Correct Use Precautions for Correct Use
• Use 0.30 to 1.25 mm
2
wire (AWG22 to 16).
• The wire inlet of M3 screw terminal block is 1.8 mm (height) × 2.5 mm (width).
• Strip the insulation from the end of the wire for 6 mm as shown below.
Connector-Terminal Block Conversion Unit (XW2B-20G )
Model Description
XW2B-20G4 M3 screw terminal block
XW2B-20G5 M3.5 screw terminal block
XW2D-20G6 M3 screw terminal block
3.5 3.5
2-
Ø
3.5
67.5
5.08
29.5
15.5
20.5
38.1
(45.3)
45
2
1
1
2
20
19
19
20
Terminal block
Flat cable connector
(MIL type plug)
Dimensions
6 mm