Omron Q2V Series, Техническое руководство

Страница: 111 / 734

Startup
Procedure
and
T
est
Run
4
4.4 Drive Mode and Programming Mode
SIEPCYEUOQ2V01A Q2V Technical Manual 111
Note:
Push and hold to go back to the frequency reference screen from any screen.
Use these steps to change C1-01 [Accel Time 1] from 1.0 s (default) to 2.0 s.
Figure 4.6 Key Operation Examples for Parameter Settings
◆
Verify and Set the Changed Parameters (Verify Menu)
Show the frequency reference screen in advance.
Note:
Push and hold to go back to the frequency reference screen from any screen.
Use Verify mode to view all parameters that are not at default settings. This is very useful when you replace a
drive. When there are no changes to parameter settings, the display shows . This lets you quickly access
and re-edit changed parameters.
Note:
The drive will only display A1-02 [Control Method] , A1-xx , A2-01 to A2-32 [MAN1 Param1 to MAN3 Param12] , and E5-01 [PM Mot
Code Selection] .
Figure 4.7 Verify and Set the Changed Parameters
◆
How to Switch between LOCAL and REMOTE
LOCAL mode lets you use the keypad to input Run commands. REMOTE mode lets you use other sources than
the keypad to input Run commands.
WARNING! Sudden Movement Hazard. If you change the control source when b1-07 = 2 [LO/RE Run Selection = Accept RUN],
the drive can start suddenly. Before you change the control source, remove all personnel from the area around the drive, motor,
and load. Sudden starts can cause serious injury or death.
You can use or MFDI functions (LOCAL/REMOTE Selection) to switch between LOCAL and
REMOTE.
Note:
1. illuminates while the drive is in LOCAL Mode.
2. While you are entering a Run command, you cannot switch between LOCAL and REMOTE.