![background image](http://html1.mh-extra.com/html/omron/nx-csg-series/nx-csg-series_how-to-connect_742409006.webp)
Rev. 1.0
4
2.1.2. Starting Sysmac Studio and Going Online
Start Sysmac Studio and go online with the Safety Controller.
1
Power up the Safety Controller and the
I/O block
2
Launch Sysmac Studio
3
Form Sysmac Studio start page select
Connect to Device
4
From the connect to device page:
•
Select the device to connect = Safety
Network Controller
•
Connection type = Ethernet
connection via a Hub
•
Connection settings = 192.168.1.1
(this is the Safety network controller
port 1 IP address)
•
Select Connect
5
If the dialog box on the right is
displayed, select OK.
*The contents of the dialog box vary
depending on the status of Controller.
Check the contents and click on an
appropriate button to proceed with the
processing.
6
When the connection is successful select
OK to finish.
7
The Auto Connect Project dialog box is
displayed.
When an online connection is
established, ONLINE with a green dot is
displayed in the Controller Status pane.