56
LD Cart Transporter User's Manual
14766-000 Rev H
3.5 Installing the Cart Brake Release
Power On
Install the power cord and turn the power switch to ON. The power switch is next to the
power plug. The blue power LED indicator should light.
Docking Station Contact Adjustment
The contacts on the docking station have five height settings. The station is shipped with the
height in the highest setting. The height can be changed by tilting the station enough to see the
bottom of the base, making the adjustment accessible.
Additional Information
: Squeeze and keep the docking station foot against the
bottom of the docking station to make this adjustment easier.
Adjust the height of the contacts by using the pull-knob on the bottom of the dock. The height
changes by 4 mm (0.15 inch) for each notch. See the following figure.
The height of the contacts should be set so that the roller is high enough to stay in contact with
the platform as it is docking, but low enough so that the bi-level of the roller guides the paddle
under the platform.
Figure 3-20. Docking Station Contact Adjusting Pull-Knob
3.5 Installing the Cart Brake Release
The two rear casters of the cart have brakes, which push a blunt pin against the caster rolling
surface to prevent the cart from rolling when it is parked on a floor that is not perfectly level.
