Omron HBF-500, Инструкция по эксплуатации

Страница: 37 / 44

ERROR INDICATORS
37
ERROR DISPLAY CAUSE CORRECTION
Your palms or feet are not positioned
over the electrodes correctly.
Make sure you are barefoot.
Make sure your palms or the soles of
your feet are clean and dry.
Make sure your feet are correctly
positioned.
Read “How to Take a Measurement”
on page 26.
The measurement position was not
stable.
Your palms or feet were not placed
correctly.
Remain still and do not move until the
measurement is complete. Read “How
to Take a Measurement” on page 26.
Feet are too dry.
Slightly moisten the soles of your feet
with a damp towel and retake the
measurement.
The Body Composition values are
outside the measurement range.
Check the settings entered for your
personal data. Change the settings
if needed. Retake the measurement.
If this error occurs again and the
settings are correct, measurements
cannot be taken.
Your palms or feet are not positioned
over the electrodes correctly.
Make sure your palms or feet are
correctly positioned.
The monitor is not set up correctly.
Remove the batteries. Wait one minute.
Reinstall the batteries. Refer to “Battery
Installation” on page 18.
Press the Power Switch and turn the
monitor on. Retake the measurement.
You stepped onto the measurement
platform before 0.0 lb was displayed.
Wait until 0.0 lb is displayed before
stepping onto the measurement
platform.
Movement during measurement.
Do not move until measurement is
complete.
Monitor detected weight over 300.0 lb.
This monitor can only be used by
people weighing less than 300.0 lb.
The monitor was moved before 0.0 lb
was displayed. Do not move the monitor until 0.0 lb is
displayed.
HBF-500 for FDA 10-26.qxd 10/26/06 4:21 PM Page 37