Omron F3SG-SR-K Series, Быстрое руководство по установке

Страница: 12 / 25

12
F3SG-SR-K
Quick Installation Manual
7. Pre-Operation Checklists / Maintenance Checklists
After wiring, mounting and beam alignment are done, check the operation of the F3SG-SR-K.
Pre-Operation Checklists
After installation, the highest level administrator must use the following checklist to verify the operation, plac
-
ing a check mark in each of the boxes.
■
Checklists
- Installation Condition Check

The machine itself does not prevent the operation of safety functions such as stopping.

The hazardous part of a machine cannot be reached without passing through the detection zone of the
F3SG-SR-K.

The system is configured so that the F3SG-SR-K can always detect a worker who is working in the
hazardous zone.

The interlock reset switch is installed in a location that provides a clear view of the entire hazardous zone
and it cannot be activated from within the hazardous zone.

The pre-reset switch is installed in a location inside the hazardous zone and where it cannot be operated
from outside the hazardous zone.

Safety distance has been calculated. Calculated distance: S = ( )mm

Safety distance has been calculated with larger object resolution when the Floating Blanking or Reduced
Resolution function is used. Calculated distance: S = ( )mm

The actual distance is equal to or greater than the calculated distance. Actual distance = ( )mm

Reflective surfaces are not installed in prohibited zones.

Not installed in a retro-reflective configuration.

When the Muting function is used, a muting sensor must be installed so that MUTING state should not
occur when a human body enters a detection zone of the F3SG-SR-K by mistake.

When the Muting function is used, a muting sensor must be installed so that MUTING state should not
occur when a human body enters a hazardous zone of a machine.

When the Muting function is used, MUTING state can be checked from where a worker operates or adjust
the machine.

A muting sensor consists of two independent devices.

It is not used in flammable or explosive atmosphere.
- Wiring Check Before Power Is Turned ON

When the power supply unit is connected to multiple devices, the power supply unit must have tolerance
against total rated current of the devices.

The power supply unit is a 24 VDC unit that conforms to the EMC Directive, Low-voltage Directive, and
output holding time specifications.

The power supply lines are wired with a proper polarity according to the wiring specifications of the PNP
or NPN setting.

Emitter/receiver cables are properly connected to the respective emitters/receivers.

Double insulation is used between I/O lines and the hazard potential (commercial power supplies, etc.).

When using PNP output, the outputs are not short-circuited to +24 VDC line. When using NPN output,
the outputs are not short-circuited to 0 VDC line.

When using PNP output, loads are not connected to +24 VDC line. When using NPN output, loads are
not connected to 0 VDC line.

All lines are not connected to commercial power source.

Model of emitter and receiver must be the same.

When two or more F3SG-SR-K systems are used, they are prevented from mutual interference with each
other.

Neither bracket must be loose.

Auxiliary output must not be used as safety output.

When using PNP output, +24 VDC line of the power supply must not be grounded. When using NPN
Mounting Wiring Operation check