E6C-N
E6C-N
10
Precautions
! WARNING
This product is not designed or rated for ensuring
safety of persons.
Do not use it for such purposes.
Precautions for Safe Use
Do not use the E6C-N at a voltage exceeding the rated voltage
range, otherwise the E6C-N may be damaged.
Do not wire power lines or high-tension lines alongside the lines of
the E6C-N in the same conduit, otherwise the E6C-N may be dam-
aged or malfunction due to induction. Be sure to wire the lines of the
E6C-N separated from power lines or high-tension lines or laid in an
separate, shielded conduit.
Do not make mistakes in wiring, such as mistakes in polarity, other-
wise the E6C-N may be damaged.
Be sure that the E6C-N is turned off when wiring, otherwise the out-
put circuit may be damaged if active output line comes in contact
with the power line.
Precautions for Correct Use
If the power supply has surge voltage, connect a surge absorber in
parallel to the power supply to absorb the surge voltage.
To protect the E6C-N from noise interference, be sure that each wire
connected to the E6C-N is as short as possible.
The E6C-N may output a pulse signal when the E6C-N is turned on
or off. Therefore, turn on each device connected to the E6C-N one
second after turning on the E6C-N and turn each device off one se-
cond before turning off the E6C-N.
The E6C-N consists of high-precision components. Be sure to han-
dle the E6C-N with care.
•
Be sure that the E6C-N is free of water or oil drops.
•
Do not short-circuit the load, otherwise the E6C-N may be
damaged.
•
If the E6C-N is mounted with a cable wired, do not pull the cable
with a force exceeding 3 kgf (29.4 N).
•
The torque required to tighten each screw must be 5 kgf
S
cm
(0.49 N
S
m) maximum. Excessive tightening torque may
damage the E6C-N.
•
Do not impose excessive loads on the shaft, otherwise the shaft
may be damaged.
Do not directly connect the shaft to chains, timing belts, or gears.
Be sure to connect the shaft through appropriate bearings and
couplings.
•
If there is a difference in angle between the shaft and the other
shaft connected, an excessive load that may damage the shaft
will be imposed on the shaft. Be sure that the shaft is connected
properly.
•
When inserting the shaft to a coupling, do not strike the shaft or
coupling with a hammer or impose any other shock to the shaft or
coupling.
•
When connecting or disconnecting the coupling to or from the
shaft, do not excessively bend, press, or pull the coupling.
Содержание E6C-N -
Страница 11: ...E6C N E6C N 11...
