D4D-
j
R
D4D-
j
R
1
3
Wiring
•
Do not connect the bare lead wires directly to the terminals but be
sure to connect each of them by using an insulation tube and
M3.5 round solderless terminals and tighten each terminal screw
within the specified torque range.
•
The proper lead wire is 20 to 14 AWG (0.5 to 2.5 mm
2
) in size.
•
Do not touch the terminals while power is being supplied in order
to avoid an electrical shock.
dz dia. 3.7
D dia.
4.5
B:
7.0
L:
20.2
F:
7.7
ȏ
:
9.0 (mm)
D dia.
dz dia.
Perform wiring for the crimp terminals in the orientation shown be-
low, so that they do not rest on the case or the cover.
Crimp-style terminal
Terminal screw
Correct
Incorrect
Crimp-style terminal
Crimp-style terminal
Correct
Incorrect
Processing the Conduit Opening
Tighten the connector to a torque of 1.8 to 2.2 N
S
m (1.37 to
1.77 N
S
m if it is a 1/2-14NPT). Excessive tightening torque may
damage the casing. To satisfy IP65, apply sealing tape to the con-
nector conduit. The diameter of the cable must be suited to the cor-
responding connector.
Insert a cap screw provided with the D4D-
j
R into any unused con-
duit opening of the D4D-
j
R and tighten the cap screw to a torque of
1.27 to 1.67 N
S
m.
Recommended Connector
Conduit size
Manufacturer
Model
Applicable
cable diameter
G1/2
OMRON
SC-6
7.5 to 9.0 mm
LAPP
(see note 1)
ST-PF1/2
5360-1002
6.0 to 12.0 mm
Ohm Denki
(see note 2)
OA-W1609
7.0 to 9.0 mm
Pg13.5
LAPP
(see note 1)
ST13.5
5301-5030
5.0 to 12.0 mm
1/2-14NPT
LAPP
(see note 1)
ST-NPT1/2
5301-6030
6.0 to 12.0 mm
Note:
1. LAPP is a German manufacturer.
2. Ohm Denki is a Japanese manufacturer.
Maintenance and Repairs
The user must not maintain or repair equipment incorporating any
D4D-
j
R model. Contact the manufacturer of the equipment for any
maintenance or repairs required.
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.
Cat. No. C103-E1-2A
