Safety Precautions
BW40T/BW55T/BW100T/BW120T
9
The use and storage environment should be in the specification scope.
Do not install or store in the following places.
+ Do not store at the places where the humidity is lower than 10% or higher than
90%.
+ Do not use at the places where the ambient temperature is lower than 0 degrees
Celsius or higher than 40 degrees Celsius.
+ Do not use at the places where the humidity is lower than 25% or higher than 85%.
+ Other places not recommended for the use or storage are: enclosed spaces such
as tightly closed cabinet; places where flammable gas or corrosive gas is stored;
places exposed to direct sunlight; extremely dusty places; places subject to
vibration and impact; outdoor, etc.
+ It may cause fire.
Do not connect the devices that exceed the output capacity of the UPS.
You can add connected equipment with table taps, etc. However, do not
connect devices exceeding the current capacity of the taps.
+ The UPS detects overload and stops the output.
+ The table tap wiring may catch the heat and cause a fire.
Do not clip or bundle the cable while using.
+ Electric shock or fire can occur due to the cable damage or heat generation.
+ Stop using the UPS if the cable has damage and immediately ask for the repair.
For information about repair, contact Omron Electronics Repair Center.
All the accessories packaged together are available only when using the
UPS. Do not use it for any other devices.
+ Make sure of observing the followings for the safe use of equipment.
Do not block inlet/outlet ports (top, sides, and rear).
+ The internal temperature may rise, eventually damaging the UPS or deteriorating
the battery.
+ Keep the unit away from 5 cm or more from the wall.
Do not connect the voltage converter and insulating transformer to the
output side.
+ Overcurrent may cause failure or abnormal behavior on the Uninterruptible Power
Supply.
+ The Uninterruptible Power Supply (UPS) may fail or malfunction even when
connecting to the input side. Ensure to check the performance before use.
Do not connect devices that don't run on the commercial power supply.
Caution
(for use)
Do not get it wet or put water on it.
+ Electric shock or fire can occur.
+ Stop using the unit, unplug the AC input cable from the outlet, and ask for the
inspection and repair in a case of the UPS got wet.
