fig. 6.7
fig. 6.9
fig. 6.8
fig. 6.5
fig. 6.6
Swivel
- Adjust the display for off centre viewing
positions. Grasp the side edges of the display and
then swivel display into the desired position, as
shown in fig. 6.5.
Panning
- Position display at an angle to the wall for
viewing from opposite sides of the room.
Grasp the side edges of the display and then swivel
and pull the display into the desired position, as
shown in fig. 6.6.
Stowing the display
- Position the display against
the wall. Grasp the side edges of the display, swivel
and pull the display into the centre position, fig. 6.7,
and then push the display straight back towards the
wall into the stowed position, fig. 6.8.
Shift
- Positioning of the displays horizontal position
relative to the wall for a better viewing. Loosen the
end panel fixed screws and grasp the side edges of
the display, shift the display to the left position, or
shift the display to the right position, fig. 6.9.
CAUTION: push the display straight back towards
the wall carefully, and make sure the cables do not
become over tight.
MAINTAINING THE M7232
Regular cleaning of this product with a clean dry cloth is usually sufficient.
For stubborn marks, wipe over gently with a clean damp cloth.
CAUTION: Be careful not to get water on the electrical connections or the display.
ADJUST THE ARM PIVOT POINTS
If more or less tension is desired in the arm pivot points, do the following:
- To increase tension, turn socket screw clockwise with Allen wrench.
- To reduce tension, turn socket screw counter-clockwise with an Allen wrench.
Do not turn more than half a turn.
fig. 6.3
fig. 6.4
knob
