6. Begin the tail wheel assembly by installing the shaft through the hole at the rear of the tail wheel
bracket. Note there is a wheel collar above and below the tail wheel bracket hole. Install the tail wheel
using two supplied wheel collars. Again, the use of thread-lock on any metal to metal screw is advised.
7. Center the tail wheel bracket on the rear of the fuselage. Screw the tail wheel assembly in place using
the two supplied wood screws. Remove the screws and harden the holes with a drop of thin CA. Allow
the CA to cure and then permanently install the tail wheel bracket. Install the rudder at this time using 4
CA hinges. Once the rudder is installed and the hinges have dried, use the third wood screw to attach the
tail wheel spring as shown in the picture below.