12
•
EN
4
Setup
Power supply
For operation, the transmitter and the receiver require two rechargeable
batteries or non-rechargeable batteries of size AA. It is also possible to use a
USB power source.
1) Remove the cover of the battery compartment and insert the batteries as
indicated in the compartment.
2) To recharge rechargeable batteries connect a power supply unit or a USB
power source to the micro USB port by means of the USB cable provided.
As soon as the charging starts, the charging indicator lights up. The
charging time is about 4 hours.
Caution!
Never attempt to charge batteries that are not rechargeable. This can
lead to explosions.
3) The capacity of the batteries is indicated by the power indicator. During
normal operation it lights up green. If the (rechargeable) batteries are
going flat, it lights up red.
4) Always insert two (rechargeable) batteries of the same type. If the unit is
not used for a longer time, it is recommended to remove the
(rechargeable) batteries to prevent damage to the unit in case of battery
leakage.
Connecting and fastening the units
1) Connect the audio source with line level (media player, radio, mixer etc.) to
the AUX IN jack of the transmitter. For voice transmission, connect a
microphone to the MIC IN XLR jack. Stereo input signals will be mixed to a
mono signal. If both jacks are connected, both the signal of the audio unit
and the microphone signal will be transmitted.
2) Connect the receiver’s AUX OUT jack to the audio input of the subsequent
unit (amplifier, mixer, camera etc.). A 3.5 mm audio cable is provided. To
monitor the audio signal on the receiver, connect earphones or
headphones to the jack.
3) The transmitter and the receiver are both provided with a clip. This clip can
be used to fasten the units e.g. on your clothes. It is also possible to use
the optional camera tripod.
