Omnitronic LH-055, Руководство пользователя

Страница: 11 / 12

00052718.DOC, Version 1.2 11/12
4. SETTING INTO OPERATION
First switch off or mute the units to be connected to prevent switching noise.
4.1 Connecting the signal source
1. Connect the unbalanced output of your musical instrument via a 6.3 mm plug to the input jack. The
connection cable between the signal source and the DI box should be as short as possible in order to
reduce interference.
2. With the sliding switch ATT the input signal can be attenuated and thus matched to the input level of the
following mixer: use the left position 0 dB e.g. for guitars, the center position for -20 dB for instruments
with line level and the right position -40 dB for loudspeakers.
4.2 Connecting the feedthrough output
The signal coming from the instrument can be transmitted directly to an amplifier. For this connect the
amplifier to the unbalanced feedthrough output PARA OUT.
4.3 Connecting the mixer
The balanced output signal with microphone level is present at the XLR output BALANCED. Connect the
output via a balanced cable of high quality to the microphone input of a mixer.
4.4 Groundlift switch
Should hum loops occur press the switch GROUND. Then the ground between the input and the output is
separated.