10355020_V_1_0.DOC
11/11
Stereo 1/4“ jack-plug:
Tip
Right
Left
Ground
Ring Sleeve
• Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet
and use the POWER-switch (Power-LED on).
• It is also possible to use the battery compartment with two 9 V batteries on the right side of the LH-020.
• Next to the MIC-sockets, the Phantom power and low cut –switches are located, whereby „P“ indicates
„Phantom power (for use with condensor mics) and „L“ indicates „Low Cut“ (to cut down unwanted low
frequencies).
To activate „P“ and „L“ you have to press down the switches (deactivate = up), wherby 1(P) and 2 (L) refer to
MIC 1; 3 and 4 to MIC 2 and 5,6 to MIC 3.
• Via the 3 LEVEL-MIC-controls you can adjust the volume of MIC 1 to 3.
• The Clip-LED flashes when the output signal starts distorting.
CLEANING AND MAINTENANCE
Disconnect from mains before starting maintenance operation!
DANGER TO LIFE!
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power consumption:
20 mA
Phantom power:
18 V DC
Input impedance:
600 kOhm
Output impedance:
600 Ohm
Max. input level:
-14 dB
Max. output level:
+14 dB
Gain:
60 dB
T.H.D.:
0.02 %
Dimensions:
143 x 93 x 45 mm
Weight:
555 g
Please note: Every information is subject to change without prior notice. 03.06.2004 ©
