00036208.DOC, Version 1.1
10/12
4.
INSTALLATION
The speaker can be fastened to the installation area via the installation equipment (mounting bracket,
aluminum tube, steel tube, steel ropes or audio cable). Before installing the system, make sure that the
installation area can hold a minimum point load of 5 times the system's load (e.g. weight 20 kg - point load
100 kg).
The installation of the device has to be built and constructed in a way that it can hold 5 times the weight for 1
hour without any harming deformation.
Please note:
when using this speaker system in public or industrial areas, a series of safety instructions
have to be followed that this manual can only give in part. The operator must therefore inform himself on the
current safety instructions and consider them.
Make sure that the area below the installation place is blocked when installing, uninstalling or servicing the
fixture.
When installing, uninstalling or servicing the speaker staying in the area below the installation place, on
bridges, under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
Procedure:
The device should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD INSTALLATION REQUIRES EXTENSIVE EXPERIENCE, including (but not
limited to) calculating working load limits, installation material being used, and periodic safety inspection of
all installation material and the device. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural installer. Improper installation can result in bodily injury and or
damage to property.
Caution:
Devices in hanging installations may cause severe injuries when crashing down! If you have
doubts concerning the safety of a possible installation, do NOT install the device!
4.1 Attachment
The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water level.
The device must be installed out of the reach of people.
This device is only allowed for an installation via the installation equipment. In order to safeguard sufficient
ventilation, leave 50 cm of free space around the device.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
4.2 Choosing an appropriate PA amplifier
This speaker must only be connected with an appropriate PA amplifier. Observe the correct power matching.
The total load presented to the amplifier must not exceed the rated output of the amplifier.
Before starting with the installation, you must clarify how many speakers you would like to install in the room.
