PI
Module - iConverter 2GXM iConverter, Serial Agent
Identifier -
Chassis Number
= 1
Switch ON condition
OFF condition
H/W
Actual
Slot Number
= 11
1: Port 1 Manual
Port 1 AN
Off
Off
Model Number
= 8999-0
2: Port 2 Manual
Port 2 AN
Off
Off
3: Not Available
Serial Number
= xxxxxxxx
4: Not Available
Manufacturing Date = xxxxxxxx
5: Not Available
Product Revision
= xx
6: Link Propagate
Link Segment
Off
Off
Software Revision
= xx
7: Remote Fault
Normal
Off
Off
8: Symm Fault Det
Normal
Off
Off
LED
9: BP A Enabled
BP A Disabled
Off
Off
1: Power
= On
10: BP B Enabled
BP B Disabled
Off
Off
2: Power Supply 1 = Off
11: Pause Enabled
Pause Disabled Off
Off
3: Power Supply 2 = Off
12: Slave Only
Master/Slave
Off
Off
4: Power Supply 3 = Off
13: Not Available
5: Port 1 Link = Off
14: Not Available
6: Not Available
15: Not Available
7: BP Master = Off
16: Not Available
8: Port 2 Link = Off
OAM settings:
9: Not Available
17: IP protocol State On
18: Management Mode Secure OAM
Toggle Switch(1-16), (I)dentifier, (R)eset, (H)elp, (P)ortStat, Port(C)tl >
The
Module
configuration screen provides general information concerning the configuration and status of
the module. The screen displays the model and serial numbers, hardware and software revisions, as well as
the condition of the LEDs and DIP-switches. The DIP-switches can be re-configured (options 1 -12)
without removing the module from the chassis. Select the appropriate option to change the DIP-switch
setting. Selecting DIP-switch options 1 - 12, will cause the selection to change states under the ‘Actual’
heading.
NOTE: The Plug-In
Module
configuration screen is shown. The standalone
Module
configuration
screen will display LED 2, 3, 4, and 7 and DIP-switches 9, 10 and 12 as NOT AVAILABLE.
Page 25
