1.
Select the mounting location
for the
TTID transmitter
on the
front of the trailer near the trailer’s
7-way receptacle
.
2.
Use alcohol wipe to thoroughly
clean the mounting surface so it
is free of dirt and wax. Allow the
surface to dry.
3.
Make note of the
TTID
transmitter number
printed on
the label on the back
of the
TTID transmitter.
This
TTID transmitter number
will be
needed for programming in the
Trailer number.
4.
Peel the protective plastic
from the VHB tape on the back of
the
TTID transmitter
and attach
squarely to the cleaned mounting
surface of the trailer.
Installing the TTID
on the Trailer
TTID Transmitter Installation
Note:
The additional UA label
attached to the protective plastic
from the VHB tape may also be
used following removal to note the
UA of the device for programming.
80-J2278-1 Rev
. D
MA
Y CONT
AIN U.S. AND INTERNA
TIONAL EXPOR
T CONTROLLED INFORMA
TION
Use the following instructions to program the Trailer ID
data into the TTID transmitter using the Field Service Tool.
Programming the Trailer ID
on the TTID Transmitter
1.
Using the
Discover field
, type the UA
of the
TTID
device to perform a search.
2.
Once the
TTID
has been discovered,
tap on the UA that appears to connect.
3.
Enter the new
Trailer ID
by selecting
the edit icon.
4.
Select the checkmark icon to program
the
Trailer ID
value on the device.
Note:
The Bluetooth
radio on each TTID
is only active
for the first five
minutes after
external power
is applied. If it
has been more
than five minutes
since the unit
received power,
the installer will
need to remove,
and reapply to
communicate
with the device.
If connected to
the Field Service
Tool, the Trailer ID
field will display
the value currently
programmed to
the device, or
“UNKNOWN-ID”
if no Trailer ID
value has been
programmed.
Discover field
Checkmark
5.
Route the
TTID transmitter
cable
into the
7-way.
6.
Connect the white ground
wire from the
TTID transmitter
cable
to
pin 1 of the 7-way
(ground).
7.
Connect the blue +12 VDC
transmitter signal wire to AUX
pin of the
7 way
(center pin on
the
7-way receptacle
).
8.
Ensure all connections
are secured and the cable will
not rub against the trailer
or be damaged in any way.
Use the supplied tie-wraps
to fasten the wires securely.
Install the
Field Service Tool application
from the
Android app
store
https://play.google.com/store/apps/details?id=com.
The application is free to download,
and requires no authentication credentials.
Edit
