5
Front aperture warning label (Fig. 2)
Manufacturer Label (Fig. 3)
Warranty Label (Fig. 4)
The manufacturer’s Label (Fig. 3) meets all requirements for both IEC (IEC 60825-1) and CDRH
Compliance. This label is located on the bottom rear panel of the projector.
If the warranty label (Fig 4) is removed it will void the manufacturer’s warranty.
Shipping a Stinger in anything other than the original packing will also VOID the warranty.
If others are in the room, please warn them you are going to turn on the laser.
The Food and Drug Administration recommends that you avoid direct eye contact with any
laser source above 1mW. Therefore you should never aim a laser into the audience.
1. Select Beam Pattern via DMX.
2. Aim beams onto a joist or along the bottom of your trussing
3. Mark the position the beams are hitting on the joist/wall/truss
4. Install Bounce mirror.
5. For Permanent Installations we recommend the use of our bounce mirror installation bracket
(OmniSistem Part # SL-GBM-BKT)
6. Target or redirect the beam to another location in the facility
7. Mark the spot where the laser is hitting and mount another bounce mirror there. Repeat this
process for each beam until your installation is complete.
8.
Once you are completed choose the beam chase pattern and you will have a professional grade
laser beam show.
CDRH Labeling Requirements
Recommended Placement and Positioning
Beam Targeting
2.5 Meters
