OmniSistem Magic Box II, Руководство пользователя

Страница: 3 / 4

Operating Modes (Cont.)
Master-Slave Operation (Auto, Sound Active Mode)
This mode allows user to link up to 32 units to run the Master-Slave operation.
In the Master-Slave operation one unit will act as the controlling unit and the
others will react to the controlling unit. Daisy chain your units via the standard
XLR microphone cables in the following configuration: ‘Out’ from the first unit to
‘In’ on the second, ‘Out’ from the second to ‘In’ on the third and so on.
Auto mode
„
To set the master: Set DIP switch pin 11 and 10 to ON, other pins to OFF.
„
To set the slaves: Set pin 1 to ON, other pins to OFF.
Sound Active mode
„
To set the master: Set DIP switch pin 11 to ON, other pins to OFF.
„
To set the slaves: Set pin 1 to ON, other pins to OFF.
Function Selection Chart
DIP SWITCHES CHART
1 2 3 4 5 6 7 8 9 10 11 12
FUNCTION
OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF
╳
SOUND MODE
OFF OFF OFF OFF OFF OFF OFF OFF OFF ON
╳
AUTO MODE
SET SOUND / AUTO MODE ON
DMX MASTER
ON OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF DMX SLAVE
SET ADDRESS OFF OFF DMX MODE
╳
/ : Not Used
Fuse Replacement
Always disconnect from main power supply before attempting to replace the fuse
Remove the old fuse from the holder and replace with the exact same type fuse.
Replacement with anything other than the specified part may damage your unit.
Cleaning
Caution: Shut off the main power prior to cleaning unit.
Cleaning mirrors
„
Use a cotton swab and rubbing alcohol to clean the internal laser mirrors.
„
Remember to twirl slowly and press gently. Applying to much pressure can
break the mirrors.
„
Cleaning frequency depends on the environment in which the fixture operates.
Cleaning case
Use a soft cloth and normal glass cleaner to clean the casing. Be sure to dry all
parts before plugging the unit back in.
Trouble Shooting
„
If there is no light from the unit, please check the main power supply and fuse.
„
If unit does not respond to DMX, please check the DMX cables are connected
properly and are wired correctly.
„
If unit does not response to the music please adjust the sound-active sensitivity
level by Sensitivity Adjustment Knob.
„
If the beam is fuzzy please refer to “cleaning“ section to clean the mirror first.
„
If problems cannot be solved please contact your dealer for service
„
You can adjust the position of green & red light by below steps to make the best
yellow effect
Step1: Set the ch1 value between 4~7, ch2 value between 66~78.
Step2: Open the cover at front panel. (Caution! Before you open the cover
please project light on to the wall. Never look into beam directly)
Step3: Control these 2 knobs to overlap green and red pattern.
R G Y
Control the green laser pattern horizontally.
Control the green laser pattern vertically.