System Layout and Connections
Before you commenced the installation, it is important to produce a schematic
diagram. The diagram will be handy for any future maintenance or upgrades to the
system. The diagram should include the location of all components, cable types,
routing and length.
This is the layout plan of how your Ulysses Mini thermal camera system will be set-up.
Joystick
Controller
Camera Turret
Junction Box
MFD / Touchscreen monitor
12V DC power supply
12V or 24V DC
power supply
NMEA 0183 data
source (if required)
Begin by selecting an apparated location to install the camera. It should ideally be
installed at a good vantage point with emphasis on forward view.
Using the Mounting Template decal provided, mark and drill all the holes required for
Camera Turret installation at the selected location.
Prepare the camera for installation by installing the provided 4 x m6 studs into the
base of the camera. (Fig.2). Be sure not to over tighten these studs as doing so may
severely damage the camera.
Pass the camera harness cable through the center hole and route it to the junction
box location. Connect the cable harness to mating connector under the camera base.
Note the orientation of the Camera Turret indicated by the “forward arrow” under the
camera and install the camera with it’s base facing toward the bow of your vessel.
Secure the camera with supplied hardware as indicated in Fig.1.
Pro Tip: Put a temporary mark of the front side of the base, to indicate the forward
side to aid installation.
Camera can be installed on a riser in the same way.
Mounting the Camera Turret
Ensure depth of screws do not penetrate more than 13mm from the base.
Failure to observe this may severely damage the product and is not
covered under the warranty.
Fig. 1
Fig. 2
