2
Hardware Kits:
Display Hardware
ID Qty Description
A 4
Philips Screws M4 x 16mm
B 4
Philips Screws M4 x 36mm
C 4
Philips Screws M4 x 45mm
D 4
Philips Screws M5 x 16mm
E 4
Philips Screws M5 x 36mm
F 4
Philips Screws M5 x 46mm
G 4
Philips Screws M6 x 16mm
H 4
Philips Screws M6 x 36mm
I 4
Philips Screws M6 x 46mm
M 4 3/4" Round Spacer
N 2 Round Washer
Wall Plate (1 pc.), Mounting Rails (2 pcs.)
Mount Hardware
Qty
Description
4
#12 Phillips Screw
4
Round Washer
4
Wall Anchor
4
Square Washer
1
Hex Wrench
1
Push Pin
7
Step 5: Lock the Display
Engage the lock by sliding the locking tab up into
place. (Fig. 9)
Make sure that the locking screw is centered in the
lock hole, and then tighten securely with the sup-
plied Hex
Wrench. (Fig. 10)
This will prevent the display from being easily re-
moved or dislodged from the wall mount.
Step 6: Tilt the Display
To adjust the tilt angle, grasp the top of the
display, and push or pull it into position as
required. If necessary, loosen both tilt ten-
sioning screws just enough so that the dis-
play can be moved by applying pressure to
the upper edge.
To lock in the tilt angle, re-tighten both tilt
tensioning screws. (Fig. 11)
Important: Always support the upper edge
of the display when adjusting the tilt angle.
Fig. 10
Fig. 9
Fig. 11
