Outside the United States
The Wall Power Supply which comes with your
Omnilux new-U is designed to operate with
an electrical input between 90-250 Volts, at
50-60 Cycles.
When traveling outside the United States,
you should check the local electrical service
for suitability if you are in any doubt.
The Wall Power Supply plug may not fit AC
outlets in countries outside the United States.
Storage
Avoid placing the Omnilux new-U in a dusty or
dirty environment. Dirt entering the air intake or
ventilation flutes will shorten the life of the unit.
The wall power supply lead should never be
sharply bent, kinked, strained or crushed.
Store the new-U in a dry environment, avoiding
extreme temperatures and direct sunlight.
Disposal
For protection of the environment, please package
and return this unit to Photo Therapeutics Inc. at
the end of its working life.
Labeling
The label on the rear face of the Omnilux new-U
contains the following information:
• Model Number
• Electrical Requirements
• Date of Manufacture
Troubleshooting
Photo Therapeutics Inc. record and analyze
all faults reported to them. The majority of
faults reported have a simple cause and can be
readily put right by the user. They are listed in
the troubleshooting table on the next page.
If the actions suggested fail to rectify the
problem, or the fault reoccurs, please refer to
Photo Therapeutics Inc. or their authorized
representative to arrange servicing of your
Omnilux new-U.
Do not attempt to investigate any further; the
Omnilux new-U has no user-serviceable parts.
NOTE that Infrared light is invisible to the eye,
therefore the Omnilux new-U is fitted with two
yellow LED indicators to show when the infrared
output is on. If the yellow LEDs do not light up
when the switch is moved to the ‘Infrared’
position, then there is no Infrared output.
PAGE 14
New-U.UserGuide.81-034.indd 16
7/11/08 8:55:38 AM
