Omniflex C1620, Руководство пользователя

Страница: 49 / 52

Omni30 User Manual - 49 - © Omniflex
UMC1620AR04
Holding/
Input
Register
No. Coil/
Input
Status. DIT No. DESCRIPTION
Read/
Write
be recognised, otherwise the DIP switch setting is used. If an invalid setting is written into these registers, the
relevant sequence is set to Sequence 1.
202 N/A 201 Setup Sequence Number: Input 4 (high byte) : Input 3 (low byte) R/W
203 N/A 202 Setup Sequence Num ber: Input 6 (high byte) : Input 5 (low byte) R/W
204 N/A 203 Setup Sequence Number: Input 8 (high byte) : Input 7 (low byte) R/W
205 N/A 204 Not Used R/W
206 N/A 205 Not Used R/W
207 N/A 206 Not Used R/W
208 N/A 207 Not Used R/W
209 N/A 208 Setup Timer Setting: Input 2 (high byte) : Input 1 (low byte)
Input delay timer set per input. One input per byte. The data format for an input is as follows:
Most significant bit:
1 = Use the slow timer, 0 = Use the fast timer (1/10 s)
Least significant 7 bits: time delay in multiples
The fast timer counts time in units of tenths of a second (i.e. 1/10 s).
The slow timer counts in multiples of the fast timer and is programmable. Refer to DIT 135 to configure it. The
default setting is 10 which makes is a seconds counter.
Fast timer example:
To delay Input 1 by 20 seconds, enter 200 (or C8 hex)
Slow timer example: If DIT 135 is set to 10 then to delay Input 1 by 20
seconds, enter 148 (94hex)
Set to 255 to use timer setting set by SW2.
R/W
210 N/A 209 Setup Timer Setting: Input 4 (high byte) : Input 3 (low byte) R/W
211 N/A 210 Setup Timer Setting: Input 6 (high byte) : Input 5 (low byte) R/W
212 N/A 211 Setup Timer Setting: Input 8 (high byte) : Input 7 (low byte) R/W
213 N/A 212 Not Used R/W
214 N/A 213 Not Used R/W
215 N/A 214 Not Used R/W
216 N/A 215 Not Used R/W
217-219 N/A 216-218 Reserved