Copyright ©2019 Omni-Rinse, LLC. All rights reserved
.
Rev. 06.01.2020
Mounting Stall to Wall With Bracket
Attaching Bracket to Stall
1. Attach Bracket to Stall by placing Stall on its side with valve
facing up. Begin mounting by inserting fasteners in top 2
mounting holes of Stall and Top Channels of Bracket
—
do not
fully tighten. (See Figs. 6-7)
2. Insert (4) additional fasteners into Bottom Channels of Bracket
—
do
not fully tighten.
3. Once all (6) fasteners are in place, slide Bracket as far as possible
toward bottom of Stall.
4. Tighten fasteners.
Mounting Completed Assembly (Stall +Bracket)
5. Determine desired location of completed assembly on wall and
affix “WALL MOUNT TEMPLATE” to wall.
TOP CHANNELS
BOTTOM CHANNELS
6. Align keyholes of template with keyholes of completed assembly
to confirm final location of machine.
7. If location adjustments need to be made, move template until
satisfied with final location of unit.
8. Once final location has been confirmed, drill pilot holes into wall
with appropriate drill bit(s) for type and material of wall.
9. Fasten (6) #12 stainless steel fasteners into wall, allowing enough
space between wall and fastener heads to use rear keyholes of
Bracket to mount completed assembly to wall.
10. Carefully place completed assembly on wall making sure all
fastener heads have cleared respective keyholes and tighten
fasteners.
11. Make fine height and level adjustments by adjusting fasteners
that secure Bracket to Stall.
12. Reassemble unit and proceed to Section 3 (pg. 6)
Fig. 6
Fig. 7
SECTION 2-D : THE CUBE / UTILITY STATION
Models BTRS-TC1 / BTRS-US1
***Steps for mounting Auto-
Rinse ™ to Cube and
Utility Station are identical***
5
1. Confirm that drain elbow is secure before proceeding.
2. Connect braided supply line to self-metering valve.
The Cube
Utility Station
