2
Model: TVM-13
Item Description Quantity
1 Wall
Bracket
1
2 Platform
1
3 Platform
Swivel
Bracket
1
4 Nose
Piece
1
5 Wall
Bracket
Cover
1
6 Square
Washer
1
7 Flat
Washer
1
8 Anti-slip
Pads
4
9 Hex
Wrench
1
10 Platform
Main
Bolt
1
11 Platform
Tilt
Screws
2
12
Platform Lock Nut
1
13 Platform
Slide
Nuts
2
14
Platform Trim Piece
1
15 Support
Arm
1
16 Support
Arm
Pivot
Bolt
1
17
Large Hex Wrench
1
18 Wall
Anchors
4
19 Wall
Bracket
Bolts
4
20 Security
Strap
1
21
Small Hex Wrench
1
3
Step 1
Use electronic stud finder to locate center of stud.
Note: When mounting to masonry, go directly to Step 2
Step 2
Use wall bracket (1) as template to mark mounting hole locations.
Step 3
Wooden Stud Mounting:
Using 1/8” drill bit, drill mounting holes to a depth of 2”.
Using a 10mm wrench, bolt the wall bracket to the wall with
the supplied lag bolts (19).
Note: To make installation easier, dab a bit of liquid
soap onto the threads before driving the bolt into the
stud.
Masonry Mounting:
Use a 3/8” masonry drill bit, and drill mounting holes to a
depth of 2”.
Insert wall anchors (18) into mounting holes, and tap flush with hammer.
Using a 10mm wrench, bolt the wall bracket to the wall with the supplied lag
bolts (19).
Step 4
Slide wall bracket cover (5) over support arm, with flat side facing wall.
Insert platform tilt screws (11) up through two
countersunk holes in bottom of Platform
Swivel Bracket (3).
Thread square platform slide nuts (13) onto
platform tilt screws. Loosely secure nuts using
small hex wrench (21).
Place flat washer (7) in depression in center of
platform swivel bracket.
Insert platform main bolt (10) through center
of washer.
Place platform assembly on top of platform
swivel bracket, with main bolt passing through
center hole.
Install square washer (6) onto platform main
bolt, and then thread platform lock nut (12)
onto platform main bolt. Tighten with hex
wrench (9). Do not
over-tighten or plat-
form will not swivel.
Step 5
Insert support arm into wall bracket. Insert support arm
pivot bolt and secure with lock nut. Do not over tighten
lock nut, or arm will not swing freely.
Snap wall bracket cover into place.
