9
DM-R160-0427A (Rev 2)
www.omnexcontrols.com
call toll free: 1-800-663-8806
Light Legend
Solid
Slow
Flash
Fast
Flash
Red
Light
Green
Light
Alternating Red
& Yellow Light
Yellow
Light
The transmitter’s Paddles and Potentiometers control the receiver’s proportional output. The Paddles/Joysticks are used
in conjunction with any of the transmitter’s switches. The proportional output can be activated when a switch is held UP
or DOWN; it will become active at an increasingly high level as the Paddle/Joystick is pushed/pulled, or a potentiometer is
adjusted. The minimum and maximum levels of the proportional output can be calibrated by following these steps.
Refer to the Light Legend below for diagram details.
NOTE: Calibration settings can be reset to factory default in steps 3 & 4 by holding the [Power] switch UP or DOWN for 5 seconds
.
A. Refer to steps in “Power the
Transmitter”
B. Supply power to the R160
B.
ESTOP
FAULT LINK STATUS
1. Power T300, Power R160
A. Hold [Power] switch DOWN
for 5 seconds until the
(Battery) LED goes to alter-
nating RED and YELLOW.
B. Release [Power] switch
2. Setup T300 into Configuration Mode
3. Set Minimum Level
A. Push the paddle (or turn the potenti-
ometer) in the direction you wish to cali-
brate until the (Active) LED comes on
B. Hold paddle and Press [Power] switch
DOWN to increase minimum level or UP
to decrease it
4. Set Maximum Level
A. Fully push the paddle (function) (or turn
the potentiometer) in the direction you
wish to calibrate until the (E-Stop) LED
comes on.
B. Hold paddle and Press [Power] switch
DOWN to increase maximum level or UP
to decrease it
5. Power Off
A. Press [E-Stop]
A.
A.
B.
A.
A.
B.
B.
Note:
Repeat steps 3 and 4 for each paddle (function) that needs to be calibrated.
A.
Calibrating Proportional Controls
