OMG MF 64, Инструкция по эксплуатации

Страница: 157 / 180

MF 64
Author: Donato Gavino Murru donato.gavino.murru@omgitaly.com Pag. 156 a 179
Troubleshooting
Symptom Probable cause Item to check Countermeasures Interventions
mode
The pieces
are not
cutting Die cut not good
The pressure of
cutting is not
sufficient.
The press
adjustment is not
good.
Die
% torque of
cutting
Exchange the die
Increase the % of
torque for cutting.
Remove the die.
Redo setup in
lower trim press
motor page in
touch screen.
Safety
Do not touch any moving parts in operations or introduce hand inside
the press during the adjustments. To do so may result in injuries.
Do not remove cover or safety devices without shutting down the
power. Before turning on power, make sure that all safety guards are
in place and that all safety devices are in good working order.
Installation, operation, maintenance, or inspection must be performed
by authorized personnel. Not doing so may result in electric shock or
injuries.