pag.9
O.M.F.B. S.p.A. Hydraulic Components
We reserve the right to make any changes without notice.
Edition 2017.05 No reproduction, however partial, is permitted.
Via Cave, 7/9 25050 Provaglio d’Iseo (Brescia) Italy Tel.: +39.030.9830611
Fax: +39.030.9839207-208 Internet:www.omfb.it e-mail:[email protected]
2.2 Use
1. Power up the receiver (insert the battery disconnector and any other switch that may be installed in
series with the receiver power supply);
2. On the transmitter: press the desired functions, remembering that, if you are controlling a RADAR
II 2 CH, the 2 commanded functions are controlled by the channel 1 Up/Down function buttons,
but if you are controlling a RADAR II 4 CH, the 4 functions correspond to the function buttons in the
first column A; if the red LED signalling the battery’s charging status lights up and the TX LED is not
active, follow the instructions in paragraph 1.6 to replace the batteries.
3. Use in combination with the RADAR II 8CH receiver
RADAR II 8CH radio remote control systems are configured thusly:
• Qty. 2 4CH Receivers;
• Qty. 1 Transmitter.
The TXF transmitter controls, respectively, the first 4CH receiver on the “Receiver A” and the second 4CH
receiver on “Receiver B” of the transmitter: in other words, to activate the devices connected to the first
receiver you must press the button “A” on the transmitter, while to control the devices connected to the
second receiver you must press the button “B”.
Note
: The receivers are perfectly identical to one another, and completely interchangeable. It is the
operator or installer who defines which is the first and second receiver, during the programming
stage described below.
3.1 Programming
1. Power up the receivers (insert the battery disconnector and any other switch present in series with the
receiver power supply);
2. On the transmitter: press a function button in the A, B or C column and make sure the TX LED lights
up flashing;
3. On the receiver 1: press the red emergency mushroom-head button: the internal buzzer begins to
emit a continuous sound;
4. See paragraph 2.1 to program with REED;
5. Make sure all functions connected to the first receiver of the radio remote control system are correctly
activated;
6. On the receiver 2: press the red emergency mushroom-head button: the internal buzzer begins to
emit a continuous sound;
7. See paragraph 2.1 to program with REED;
8. On the transmitter: press one of the function buttons (channel 1 Up/Down or channel 2 Up/Down)
in the column on which you wish to program the receiver, with the exception of those already
programmed in A, B or C.
9. Make sure all functions connected to the radio remote control system are fully functional.
Test that the emergency function from the Transmitter is sent to the two receivers.
3.2 Use
1. Power up the receivers (insert the battery disconnector and any other switch that may be installed in
series with the receiver power supply);
2. On the transmitter: press the desired functions, remembering that the first column is for receiver A
and the second column is for receiver B.
3. The transmitter automatically switches off.
101-050
USER AND MAINTENANCE MANUAL
“RADAR NEW TXF”
Codice foglio: 997-101-50366 R
ev: //
Data: V
enerdì 16 giugno 2017
Codice fascicolo: 997-101-50370
