Reproduction of part or all of the contents of this document in any form is expressly prohibited other than for individual use only.
All text, images and labels are property of Nimax Gmbh.
Figure 6
Start by removing the battery’s compartment cap. Insert a coin in the cap’s slot and rotate counter-
clockwise. Insert the batteries as shown. Make sure to insert it in the correct position (negative end
first) – figure 3. Retighten back the cap so that the batteries do not shake.
Turn the device ON by pressing the Power/selector button for 3 seconds. Remove the dust cap. Look
through the eyepiece. The LCD display should be
illuminated. To power OFF press for another 3
seconds until the display turns off.
Main screen features (figure 4)
1. Battery charge status
2. Remaining image space
3. Capture mode
4. Record support
The supplied batteries can be recharged
through the 5V DC IN socket.
Figure 4
Figure 5
Figure 3
When the device is turned to ON the display will show
some icons as shown in figure 4. Notice that every
time the device is disconnected and connected the
capture mode is set to Photo mode.
Brightness adjustment (figure 5)
Brightness of the screen can be adjusted. Press the
IR button (#13 – figure 1). “Bright:” will appear on
the screen. Press UP and DOWN to adjust the
brightness. In this example “7”. There are 9 levels of
brightness from 1 to 9. Press UP to increase and
DOWN to decrease brightness. To exit brightness
adjustment press IR button again.
Infrared illumination (figure 6)
The IR illumination improves the range and the
brightness of the image. To adjust IR illumination
press the IR button twice (#13 – figure 1).
“*LAMP:” will show on the screen. Press UP and
DOWN to adjust the illumination. In this example
“4”. There are 9 levels of illumination from 1 to 9.
Press UP to increase and DOWN to decrease
illumination. To exit illumination adjustment press
IR button again.
