9
Section 7 - Battery Installation
Battery Installation or Replacement
UWTC-1, UWTC-2, UWRTD-1, UWRTD-2
To install or replace the battery in your Connector/
Transmitter you must first remove the two screws located on the back side of
your device. This will allow you to access the battery compartment.
Battery Replacement UWTC-1, UWTC-2, UWRTD-1, UWRTD-2
Battery Replacement
Your NB9 is equipped with a “C” size lithium power cell assembly. Omega
Part Number: UWTC-BATT-NB. To install replacement battery assembly
follow steps outlined here.
A. Remove the two screws that secure
the main circuit board from the
probe head assembly.
B. Tilt the front of the circuit board
just high enough to allow you to
unplug the connector that attaches
the battery assembly to the bottom
of the circuit board.
C. Remove the old power cell.
D. Install your new battery assembly
into the housing in the same
position as the old battery was
located.
E. Connect the battery assembly
connector to the mating connector
on the bottom of the circuit board.
F. Install the circuit board back into
the housing and secure with the
two screws you removed in step
one.
G. Installation complete
Battery Replacement
Battery Installation
7
BATTERY
+
–
ASSEMBLY
CONNECTOR
BATTERY
ASSEMBLY
ENCLOSURE
BOARD
CONNECTOR
CIRCUIT BOARD
MOUNTING SCREWS
