Omega RS-3, Руководство по эксплуатации и установке, Страница: 4 / 7

14
W I R I N G - 7-WIRE CONNECTOR
Black Wire:
Connection Required
Connect the Black wire to a very good, clean chassis ground. Recommended
areas are to an existing machine thread bolt, either in the driver's kick panel area
or a major structural member behind the dash (see diagram #4). Small dash braces
are not adequate, and the area must be clean, bright metal. Use the largest exist-
ing machine threaded bolt available. Using a sheet metal screw or grounding to
sheet metal is inadequate (see diagram #5 on page 15).
Black Wire
Control Module
Diagram
#
4
15
Ring Terminal
Black Wire
"Star" Washer
Self-Tapping Screw
Diagram
#
5
16
White Wire:
Connection If Desired
The function of the White wire is to supply a 12 Volt signal to the vehicle’s
exterior parking-lights in order to visually confirm system operations.
Connect the White wire to the vehicle's 12 Volt parking-light circuit
(See diagram
#
6
on page 17).
-The correct wire will show 12 Volts only when the headlight switch is in the "Parking
Light" and "Head Light" positions.
-This wire can usually be found at the headlight switch.
Note # 1: When such a wire is located, be sure to also test that it is non-rheostated:
While metering the wire, operate the dash light dimmer control. The correct wire will
show no change in voltage when the dimmer is operated.
Note
#
2: Some vehicles have a parking-light relay which is triggered by a Negative
signal from the headlight switch. In these vehicles, the White wire must be
connected after the relay, usually at the Fuse/Junction Block.
Note
#
3: Some vehicles are equipped with a split parking light system. In these
vehicles, the use of IN4006 diodes are required (see diagram #7 on page 17).
WARNING:
- Do NOT connect the white wire directly to the vehicle’s headlights. An
external relay is required.
17
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
12345
12345
12345
12345
12345
12345
12345
12345
12345
12345
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
12
12
12
12
Dash Board
Lights
Control
Module
Parking Lights
Light
Switch
White Wire
Diagram
#
6
Connecting Separate Left And Right Parking Lights Using Two Diodes.
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
Right Side Circuit
White Wire
Light
Switch
Left Side Circuit
Parking Lights
Control
Module
Diagram
#
7
Note: Use Two IN4006 Diodes.