Omega OO747X, Инструкция по эксплуатации

Страница: 14 / 20

14
6. Repeat the same operations of point 1 then push the knob until End appears. The control shows the
“current time + cooking time” as the initial stop time. It’s not possible to lower the end of cooking time below
this value. In order to set the actually desired end of cooking time in a 24 hours range:
- Turn the knob left/right, the hours flash.
- Modify the flashing hours value turning the knob left/right.
- Push the knob to switch back and forth between hours and minutes or wait a few seconds until the minutes
flash.
- Modify the flashing minute’s value turning the knob left/right.
- Wait until the new End of Cooking time value stops flashing.
The display will flash End and its value alternatively for a few seconds then it will show the time of day and the
letter to indicate that a delayed cooking has been programmed. As soon as the delay time expires, the oven
starts and works for the programmed cooking time. The symbol is displayed.
At the end of any timed activity the control shuts down the oven, the buzzer sounds a warning sequence (two
short beeps repeated every 3 seconds) to recall the user attention, for a maximum time and makes the time
related icons ( , ) flash on the display. Push the knob to silent the buzzer and reset the warning message.
Turn the mode selector to ZERO (OFF) position before reusing the oven.
Oven functions
The control can manage many cooking functions, here below described, their number and availability
depends on the oven model. The temperature range is between 50°C and 250°C for most functions.
Preset temperatures are mainly 190°C for convection modes, 210°C for thermal modes and 230°C for grilling
functions
Defrost
This function is used to defrost frozen food in a short time. It doesn’t heat up the oven, only the convection fan
works. The temperature display shows
dEF to indicate that this special mode is active.
Commands lock for children safety Hold the Time & Temp knob for about 3 seconds to lock the control
panel commands and prevent children from turning on the oven freely. Both knobs are disabled.
Buzzer volume
The buzzer volume can be set turning the Time & Temp knob left/right when the control is in light mode. At
any detents the buzzer sounds a double beep, selecting the volume out of three available levels. The buzzer
must always be silent between 22:00 and 8:00.
Failure declarations and error codes
The control is continuously checking the status of the system. If an abnormal condition is detected for more
than 1 minute, a failure occurs:
- The heaters and the other loads are disabled.
- The display shows a “E” letter followed by a numeric code that depends on the kind of failure.
- The control emits an acoustic warning signal.
To reset a failure declaration, first remove the cause of the failure then turn the selector to (ZERO) OFF.